Sorry if this is a bit of a dumb newbie question ( ), but does anyone know if you can put aftermarket end cans designed for a Raptor 1000 onto a Raptor 650ie?
My welding and fabrication skills are non-existent, so I was wondering if the link pipes and hanging points are the same for the two models?
Exhausts from 1000 fit a 650?
Exhausts from 1000 fit a 650?
Four wheels move the body.
Two wheels move the soul.
------ X-Rap 188/999 ------
Two wheels move the soul.
------ X-Rap 188/999 ------
Thanks for the responses and useful info. I was considering buying some 2nd hand cans for the 1000 then getting them adapted to the 650. Would work out cheaper than buying them new and sending the bike away for two weeks to get measured/fitted (which is what Quill wanted to do)!
As it is, some @*~# had their own ideas and knocked me off (then drove away) a couple of weeks ago. Haven't seen the bike, as the boys in blue have it for evidence, but apparently it's a real mess.
Hasn't put me off though - thinking I should get a 1000 instead!
As it is, some @*~# had their own ideas and knocked me off (then drove away) a couple of weeks ago. Haven't seen the bike, as the boys in blue have it for evidence, but apparently it's a real mess.
Hasn't put me off though - thinking I should get a 1000 instead!
Four wheels move the body.
Two wheels move the soul.
------ X-Rap 188/999 ------
Two wheels move the soul.
------ X-Rap 188/999 ------