If you look at the pic below you'll see that the little spigot that the top stand spring bracket locates around has snapped off.
![Image](http://i81.photobucket.com/albums/j237/Algrob/stand_zps13e46c55.jpg)
The hole in the bracket on the right hand side usually locates over the little spigot (that comes off a part of the frame) and runs in its groove.
As a fix I'm thinking of drilling through the frame extension and using a 4/6/mm (not measured yet) bolt/set screw with assorted nuts as in the rubbishy drawing below.
Can anyone tell me what type of bolt I need i.e hardened? High tensile? Stainless steel? Hopefully getting the correct bolt will give it a reasonable lifespan.
![Image](http://i81.photobucket.com/albums/j237/Algrob/standy_zps29a8cd05.jpg)